Join Date: Apr 2013. Posts: 7. dpf removal without an ECU remap. Hi, i recently bought a 08 mazda3 1.6d takara and within 6 weeks the dpf was was totally blocked and the car pretty much shut down (cut out after 1500rpm) and the 2 pipes with pressure sensors blew. So, my mechanic removed the dpf honeycomb with hammer and chisel, put the dpf back The DPF light first started flashing in 2010 and I had it serviced independently. The DPF light remained flashing and my garage (I had used them for years and have found them trustworthy and reliable) advised me to take it to another independent outlet to get the DPF "regenerated", which I did. All remained well till service needed in October 2011. Mazda 6 1st Generation (2002-2008) Engine / Drivetrain. 2.0 diesel 2006 mazda 6 check engine light dpf limp mode. Jump to Latest 2006 Mazda 6: diesel..dpf warning light flashing which has been solved I have a 2006 Mazda 6 diesel which has done 105,000 miles. I have had three instances of the DPF warning light flashing which has been solved by taking to local dealership. First time - P243C dpf regen frequency, P117a engine oil over temp - oil level slightly high, checked PIDs - pm acc to high - injection correction done, checked boost pressure sensor - ok, carried out pdf regen -- suvvessful PIDs within spec, replaced oil, reset oil data - all ok. My 2008 (1st Gen) 2.0 TS has had its DPF light flashing for almost 2 years with no obvious detriment to performance. Mazda 6 1st Generation (2002-2008) axIFf. I only joined the forum to post this ! If the DPF light is flashing it is probably because it wasn't reset at your last service. Most common reason for flashing DPF is that it is the "Service overdue indicator". To resolve the flashing PDF light invovolved a trip to Mazda at Bognor Regis and cost £135 for an oil filter and oil change plus reset PDF. The Mazda semi-synthetice oil was £9.50p a litre please compare with Comma fully synthetic above. Hi. I'm new to forum. I have a mazda 6 2009 2.0d sport with fsh and 133k miles. I've owned the car from 39k miles and often travel on motorways. A few months back I had a flashing dpf light and shortly afterwards engine management light and limp mode. The DPF will undergo passive and active regeneration, as you drive. If the DPF is starting to fill up, just give it a clean (don’t wait till the ash plugs are impacted, the DPF light is flashing, and your stuck in limp mode), reset, and continue enjoying your car!!! 🙂👍 Happy Days Bro. Lær på under 1 min at nulstille din blinkende DPF og spar penge på værkstedsbesøg. Jeg har prøvet det 3 gange nu og jeg har ikke kunnet mærke forskel på bile

mazda 6 dpf light flashing reset